Fitters

Contact Details

Name Company Phone Email Address 1 Address 2 State Postcode

Question 1

Purple Line products can be fitted to most Australian caravans with the use of?

A) Purple Line chassis adapter plates

B) Hand clamps

C) No more nails adhesive

Please select your answer.

Question 2

 Purple Line caravan movers fit directly onto Al-Ko and C-section chassis with no requirement for chassis adapter plates?

A) True

B) False

Please select your answer.

Question 3

Before starting to fit a Purple Line caravan mover all fitters must first

A) Read the instructions and watch the step by step fitting guide video available on the homepage of www.purpleline.com.au, in order to make the fitting job quicker and easier

B) Throw the instruction book away, ignore the video and get on with the job

C) Watch the video and ignore the manual

Please select your answer.

Question 4

Before fitting Purple Line Caravan movers, it is essential that you ensure that the motors are:

A) In the engaged position

B) In the disengaged position

C) Halfway between engaged and disengaged

Please select your answer.

Question 5

Before fitting Purple Line Caravan movers, it is essential that you ensure that the power supply is:

A) Plugged in to a mains supply

B) Fully disconnected

C) Is above 24 Volts

Please select your answer.

Question 6

The minimum space required between wheel and door (if the door is built into the chassis) on a tandem axle caravan, which requires four motors, is:

A) 200mm

B) 300mm

C) 350mm

Please select your answer.

Question 7

The correct distance (which is absolutely essential to check during fitting) between the roller and the wheel when the mover is disengaged is?

A) 200mm

B) 30mm

C) 20mm

Please select your answer.

Question 8

When situated correctly the caravan mover's roller should engage with?

A) The top of the tyre, at a 45 degree angle

B) The centre of the tyre, in line with the axle

C) Below the axle

Please select your answer.

Question 9

Can a single set of motors be mounted to the rear of the wheel rather than the front?

A) Yes, you simply need to connect the wires to the terminals in reverse, as per the instructions in the manual

B) No, it must be mounted forwards of the wheel on a single axle

Please select your answer.

Question 10

To change the caravan mover into Quattro mode, during a four motor set-up, the process is:

A) Turn off power, remove one battery from the handset, insert battery back in while holding bottom left button, hold until double beeping stops, turn power back on, re-synch handset with both receiver units

B) Purchase separate Quattro control units and handsets

C) Remove one battery from the handset, insert battery back in while holding bottom left button. Use immediately.

Please select your answer.